Dualit AWS D2AMHA Manuel D'instructions page 19

TROUBLESHOOTING
Your toaster is designed to last and be repaired in the event of a fault. Read the guide below;
MY TOASTER IS NOT WORKING:
• Check the toaster is plugged in.
• Check if the 'Toasting Warning Light' is glowing red when the timer is activated.
If yes, your elements, 'selector' switch or your thermal fuse may need replacing.
If no, your timer may need replacing. Isolate and do not use. Contact a Dualit repair centre.
I GET UNEVEN TOASTING:
• Check the selector switch is set for the number of slots being used.
• Starting from the left, ensure you have loaded all heated up slots.
• The heavy duty Proheat elements can take a few moments to reach optimum toasting
temperature. Preheating the slots prior to inserting your bread will eliminate this. Rotate the
'timer' all the way round, let it wind down to the circle indicator then insert your bread into
the active slots.
• Ensure size and type of bread being toasted is the same.
• End elements take a little longer to warm up than centre elements, once toaster is at
optimum operating temperature this will no longer occur.
• If the timer is noticably slow, isolate and do not use the toaster, risk of fire.
Spare timers are available from www.dualit.com and must be fitted by an authorised
Dualit repair centre or Dualit service engineer.
MY TOASTER WOBBLES ON MY WORK SURFACE:
• Use the adjustable foot under the toaster to compensate for uneven surfaces.
MY TOAST GETS STUCK WHEN I EJECT FROM THE TOASTER:
• Isolate and allow to cool before attempting remove the toast. Note: slices thicker
than 28mm will get stuck. Hand cut slices must be cut evenly.
• Using a 'sandwich cage' can make toasting thicker items easier.
ONE SIDE OF MY BREAD IS NOT TOASTING:
• One or more of the elements may need replacing, call the helpline or visit
www.dualit.com for replacements.
All manuals and user guides at all-guides.com
19