1. Remove the air filter cover and remove the air filter.
2. Put the air filter in a plastic bag.
3. Put the air filter oil in the plastic bag.
The engine does not start
Check
Possible cause
Starter pawls.
The starter pawls cannot move freely.
Fuel tank.
Incorrect fuel type.
Spark plug.
The spark plug is dirty or wet.
The spark plug electrode gap is incorrect.
The spark plug is loose.
16
4. Push the plastic bag to make sure the oil supplies
equally across the air filter.
5. Push on the air filter, while in the bag, to remove
the air filter oil that is not necessary. Remove the air
filter from the bag.
6. Install the air filter.
To add grease to the bevel gear
•
Make sure that the bevel gear is filled ¾ full with
bevel gear grease.
Troubleshooting
Procedure
Remove the starter cover and clean around
the starter pawls.
Let an approved servicing dealer help you.
Drain the fuel tank and fill with correct fuel.
Make sure that the spark plug is dry and
clean.
Clean the spark plug. Make sure that the
electrode gap is correct. Make sure that the
spark plug has a supressor.
Refer to
rect electrode gap.
Tighten the spark plug.
Technical data on page 17 for cor-
941 - 010 - 25.07.2023