Makita CG100D Manuel D'instruction page 10

2. Make a hole on the protective film with the tip of
the nozzle.
1
Fig.13
► 1. Nozzle
3.
Attach the nozzle to the cartridge.
NOTICE:
Be sure to check the cartridge for
damage before installation. Using the damaged
cartridge may cause malfunction.
Installing cartridge to holder A
1. Pull the rod handle backward slowly until it stops.
Fig.14
► 1. Rod handle
2. Insert the cartridge into the holder as shown in the
figure.
Fig.15
3.
Push the rod gently until the piston touches the
bottom of cartridge.
To remove the cartridge, pull the rod backwards until it
stops, then lift out the cartridge.
Installing cartridge to other than
holder A
1. Pull the rod handle backward slowly until it stops.
Fig.16
► 1. Rod handle
2. Insert the cartridge into the holder.
3. Attach the holder joint (as a cap) by turning it
firmly while holding the holder.
1
Fig.17
► 1. Holder 2. Cartridge 3. Holder joint (as a cap)
4.
Push the rod gently until the piston touches the
bottom of cartridge.
To remove the cartridge, follow the installation proce-
dure in reverse.
Using film type package
Preparing package for use
Cut off the tip of the package.
Fig.18
10 ENGLISH
2
3
1
1