Makita 6842 Manuel D'instruction page 4

FUNCTIONAL
DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function
on the tool.
Switch action
► 1. Lock button 2. Switch trigger
CAUTION:
• Before plugging in the tool, always check to see
that the switch trigger actuates properly and
returns to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and
then push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
Reversing switch action
A
► 1. Reversing switch lever
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the
A side for clockwise rotation or from the B side for coun-
terclockwise rotation.
1
2
1
CAUTION:
• Always check the direction of rotation before operation.
• Use the reversing switch only after the tool
comes to a complete stop. Changing the direc-
tion of rotation before the tool stops may dam-
age the tool.
Hook
The hook is convenient for hooking the tool to your belt.
It can be installed on either side of the tool.
Changing the installation position of hook allows two-way set-
ting of 10 mm and 20 mm (13/16") distance from the tool itself.
The tool with hook can be hung on the waist belt, a
maximum diameter 20 mm (13/16") pipe etc.
To remove the hook, just remove the clamping screw. Place it
on the tool and secure it with the clamping screw to install.
1
► 1. Hook 2. Clamping screw
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Installing or removing the bit
Loosen the thumb screws which secure the casing. Pull
out the casing in the direction of the arrow.
B
1
► 1. Casing 2. Thumb screw
4 ENGLISH
2
2