Husqvarna 1-8DPS30 Manuel D'utilisation page 20

2. Clean the chain with cleaning agent.
3. Remove dirt from internal parts of the chain.
To remove and install the control cage
1. Remove the feed spout.
2. Remove the 2 nuts, the 4 washers, the 2 cage
clamps and the control cage.
3. Install the control cage in the opposite sequence.
To replace the blastwheel
1. Remove the feed spout and the control cage. Refer
To remove and install the control cage on page
to
20 .
20
2. Remove the 3 nuts, the control cage lever, the 4
washers and the lastwheel cover.
3. Put an applicable tool in the blastwheel to prevent
rotation. Remove the bolt and discard it.
4. Remove the blastwheel.
5. Install the new blastwheel in the opposite sequence.
CAUTION:
when you install a new blastwheel.
Always use a new bolt
2087 - 001 - 23.02.2023