Publicité
Les langues disponibles
Les langues disponibles
4. Open the drive chain cover.
5. Install the quick release pin. Push and hold the quick
release pin with a finger.
6. Use your other hand to operate the drive system
lever.
2087 - 001 - 23.02.2023
The quick release pin locks into position when the
drive system is engaged.
7. Close the drive chain cover.
8. To disengage the drivesystem, pull out the quick
release pin.
Abrasive valve
The magnetic abrasive valve controls the flow of the
abrasive shot to the blastwheel. The adjustment of
the abrasive valve is shown on the ammeter. Refer to
Ammeter on page 8 .
The abrasive valve is adjusted with the abrasive control
To operate the abrasive valve on page
cable. Refer to
11 .
To operate the abrasive valve
CAUTION:
valve when the blast motor is in operation.
1. Pull the abrasive control cable to open the abrasive
valve and adjust the flow of abrasive shots.
Only open the abrasive
11
Publicité
