Publicité
Les langues disponibles
Les langues disponibles
2. Push the abrasive control cable to close the abrasive
valve and adjust the flow of the abrasive shots.
Abrasive seal
The abrasive seal makes sure that the abrasive stays
in the product during operation. The abrasive seal has
magnetic seals (A) on the sides and in front of the
blast housing. Brush lists (B) are attached around the
magnetic seals.
The skid seal (C) moves on the surface.
A
B
C
To adjust the height of the magnetic
seals
The correct height adjustment of the magnetic seals is
8-10 mm/0.3-0.4 in. from the surface.
12
1. Loosen the 2 adjustment screws at the rear wheels
to set the correct height.
2. Loosen the adjustment screw at the front wheel to
set the correct height.
3. Tighten the screws.
To adjust the height of the brush list
seals
The correct height adjustment of the brush lists is 1 mm/
0.04 in from the surface.
2087 - 001 - 23.02.2023
Publicité
