Publicité
Les langues disponibles
Les langues disponibles
4. Connect this mount bracket to the tip
of the safety wire.
Safety wire (Accessory)
Mount bracket
5. Insert the 1st anchor bolt into the
mounting hole of the mount bracket.
Mounting hole
6. Secure the mount bracket to the ceil-
ing board with the ceiling board fixing
screws (4 positions).
Turning the ceiling board fixing screws
clockwise provides ceiling board tighten-
ing between the bottom of the mount
bracket and ceiling board fixing bracket
resulting in mount bracket securing.
(Recommended tightening torque:
0.78N·m {0.58 lbf·ft})
6
All manuals and user guides at all-guides.com
Roof space
Insert the mount
bracket into the hole
Important: When securing this bracket
on the ceiling, make sure that the
four ceiling board fixing brackets are
open as shown in the following fig-
ure.
1st anchor bolt
Double nuts (locally
procured)
Ceiling board
fixing bracket
Ceiling board
7. Use double nuts (locally procured) to
secure the mount bracket after insert-
ing the 1st anchor bolt.
8. Use the driver bit supplied with the
camera to remove the screws that
secure the camera enclosure and
remove the enclosure from the camera
main body.
Important: Refer to the Operating Inst-
ructions of the camera as well.
9. Perform camera wiring.
Ceiling
board fixing
screw
Turn clockwise
Publicité
