Bosch 1209 Consignes De Fonctionnement/Sécurité page 9

BM 2609932751 09-09:BM 2609932751 09-09 9/3/09 7:20 AM Page 9
INSTALLING ACCESSORIES
(Model 1210 only)
1. Insert the locking pin provided into hole in
the spindle, to prevent the spindle from
rotating.
2. Hold locking pin in place and rotate collet
nut counter-clockwise with the (14mm) wrench
that is provided.
Service
Preventive maintenance
W RNING
performed by unauth-
orized personnel may result in misplacing
of internal wires and components which
could cause serious
recommend that all tool service be performed
by a Bosch Factory Service Center or Autho-
rized Bosch Service Station.
TOOL LUBRICATION
Your Bosch tool has been properly lubricated
and is ready to use. It is recommended that
tools with gears be regreased with a special
gear lubricant at every brush change.
CARBON BRUSHES
The brushes and commutator in your tool
have been engineered for many hours of
dependable service. To maintain peak
efficiency of the motor, we recommend every
two to six months the brushes be examined.
Only genuine Bosch replacement brushes
specially designed for your tool should be
used.
BEARINGS
After about 300-400 hours of operation, or at
every second brush change, the bearings
All manuals and user guides at all-guides.com
3. Insert three fourths of shank of accessory
into the collet, and securely tighten with the
wrench provided.
Repeat steps 1 and 2 of above and remove
accessory.
Maintenance
should be replaced at Bosch Factory Service
Center or Authorized Bosch Service Station.
Bearings which become noisy (due to heavy
load or very abrasive material cutting) should
be replaced at once to avoid overheating or
motor failure.
hazard. We
the power supply before cleaning or
performing any maintenance. The tool may
be cleaned most effectively with compressed
dry air. Always wear safety goggles when
cleaning tools with compressed air.
Ventilation openings and switch levers must
be kept clean and free of foreign matter. Do
not attempt to clean by inserting pointed
objects through openings.
plastic parts. Some of these are: gasoline,
carbon tetrachloride, chlorinated cleaning
solvents,
detergents that contain ammonia.
-9-
REMOVING ACCESSORIES
Cleaning
To avoid accidents always
W RNING
disconnect the tool from
Certain cleaning agents
C UTION
and solvents damage
ammonia and household