Black & Decker PRO Serie Mode D'emploi page 9

• Make sure that the disc locates correctly on the inner
flange.
• Place the outer flange (14) onto the spindle. When fitting
a grinding disc, the raised centre on the outer flange
must face towards the disc (A in fig. E). When fitting a
cutting disc, the raised centre on the outer flange must
face away from the disc (B in fig. E).
• Keep the spindle lock (4) depressed and tighten the
outer flange using the two-pin spanner (15) (fig. F).
Removing
• Keep the spindle lock (4) depressed and loosen the
outer flange (14) using the two-pin spanner (15) (fig. F).
• Remove the outer flange (14) and the disc (12).
Use
Warning! Let the tool work at its own pace. Do not overload.
• Carefully guide the cable in order to avoid accidentally
cutting it.
• Be prepared for a stream of sparks when the grinding or
cutting disc touches the workpiece.
• Always position the tool in such a way that the guard
provides optimum protection from the grinding or cutting
disc.
Switching on and off
• To switch the tool on, press the lock-off button (2) and
subsequently press the on/off switch (1).
• To switch the tool off, release the on/off switch (1).
Warning! Do not switch the tool off while under load.
Hints for optimum use
• Firmly hold the tool with one hand around the side
handle and the other hand around the main handle.
• When grinding, always maintain an angle of approx. 15°
between the disc and the workpiece surface.
All manuals and user guides at all-guides.com
Maintenance
Your Black & Decker corded/cordless appliance/tool has
been designed to operate over a long period of time with a
minimum of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Warning! Before performing any maintenance on corded/
cordless power tools:
•
•
•
•
•
•
•
Accessories
The performance of your tool depends on the accessory
used. Black & Decker accessories are engineered to high
quality standards and designed to enhance the performance
of your tool. By using these accessories you will get the very
best from your tool.
Mains plug replacement (U.K. & Ireland only)
If a new mains plug needs to be fitted:
•
•
•
Warning! No connection is to be made to the earth terminal.
Follow the fitting instructions supplied with good quality
plugs. Recommended fuse: 13 A.
Switch off and unplug the appliance/tool.
Or switch off and remove the battery from the appliance/
tool if the appliance/tool has a separate battery pack.
Or run the battery down completely if it is integral and
then switch off.
Unplug the charger before cleaning it. Your charger does
not require any maintenance apart from regular cleaning.
Regularly clean the ventilation slots in your
appliance/tool/ charger using a soft brush or dry cloth.
Regularly clean the motor housing using a damp cloth.
Do not use any abrasive or solvent-based cleaner.
Regularly open the chuck and tap it to remove any dust
from the interior (when fitted).
Safely dispose of the old plug.
Connect the brown lead to the live terminal in the new
plug.
Connect the blue lead to the neutral terminal.
ENGLISH
9