VOLTCRAFT DT 2 L / k Notice D'emploi page 23

Replacing the Battery
Your measuring device must be equipped with 4 batteries (AA).
When the low battery signal "LO" appears in the display you have to
replace the battery.
Proceed as follows:
At the back of the measuring instrument, the battery compartment
is secured with two recessed head screws Take a suitable cross-
tip screwdriver and remove the two screws. Carefully remove the
cover. The battery compartment is now open and the battery is
free. Remove the low battery and insert a fresh one of the same
type with the correct polarity. Close the battery compartment
carefully. Make sure that you only fasten the screws by hand. Do
not force them!
Warning!
• If the battery does not have the correct polarity,
this will inevitably destroy the measuring instru-
ment. Do not operate the measuring instrument
while it is open.
• Do not leave used batteries in the instrument since
even leakage-protected batteries can corrode
releasing chemical agents that might harm your
health or destroy the battery compartment.
• Please consider that used batteries are hazardous
waste. They must be disposed of in an environ-
mentally compatible way. You can return your
used batteries free of charge to the local disposal
institutions, to all our subsidiaries and wherever
batteries are being sold.
22
All manuals and user guides at all-guides.com