Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Crown molding stoppers (optional accessories)
allow easier cuts of crown molding without tilting
the saw blade. Install them on the base as shown
in the figures.
1
► 1. Crown molding stopper L 2. Crown molding stop-
per R 3. Base
Position crown molding with its WALL CONTACT
EDGE against the guide fence and its CEILING
CONTACT EDGE against the crown molding
stoppers as shown in the figure. Adjust the crown
molding stoppers according to the size of the
crown molding. Tighten the screws to secure the
crown molding stoppers. Refer to the table (C) for
the miter angle.
2
1
► 1. Guide fence 2. Crown molding 3. Crown molding
stopper 4. Screw
Table (C)
Position in
Miter angle
Fig. A
(1)
Right 45°
For inside
corner
(2)
Left 45°
(3)
For outside
corner
(4)
Right 45°
2
3
3
4
Finished piece
Save the right side of blade
Save the left side of blade
Save the right side of blade
Save the left side of blade
Cutting aluminum extrusion
► 1. Vise 2. Spacer block 3. Guide fence 4. Aluminum
extrusion 5. Spacer block
When securing aluminum extrusions, use spacer
blocks or pieces of scrap as shown in the figure to
prevent deformation of the aluminum. Use a cut-
ting lubricant when cutting the aluminum extrusion
to prevent build-up of the aluminum material on
the blade.
CAUTION:
•
Never attempt to cut thick or round aluminum
extrusions. Thick aluminum extrusions may
come loose during operation and round alumi-
num extrusions cannot be secured firmly with
this tool.
Wood facing
Use of wood facing helps to assure splinter-free
cuts in workpieces. Attach a wood facing to the
guide fence using the holes in the guide fence.
See the figure concerning the dimensions for a
suggested wood facing.
Over 10mm (3/8")
1
105mm
(4-1/8")
► 1. Hole
CAUTION:
•
Use straight wood of even thickness as the
wood facing.
•
Use screws to attach the wood facing to the
guide fence. The screws should be installed so
that the screw heads are below the surface of
the wood facing.
•
When the wood facing is attached, do not turn
the turn base with the handle lowered. The
blade and/or the wood facing will be damaged.
17 ENGLISH
1
2
3
4
5
Over 580mm (22-3/4")
28mm (1-1/8")
115mm
115mm
105mm
(4-1/8")
(4-1/2")
(4-1/2")
98mm
(3-7/8")
1
Publicité
Table des Matières
