Makita JV101D Manuel D'instruction page 6

Selecting the cutting action
► 1. Cutting action changing lever
This tool can be operated with an orbital or a straight
line (up and down) cutting action. The orbital cutting
action thrusts the jig saw blade forward on the cutting
stroke and greatly increases cutting speed.
To change the cutting action, just turn the cutting action
changing lever to the desired cutting action position.
Refer to the table to select the appropriate cutting
action.
Position Cutting action
0 Straight line cutting
action
I Small orbit cutting
action
II Medium orbit
cutting action
III Large orbit cutting
action
Switch action
CAUTION:
Before installing the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released.
CAUTION:
When not operating the tool,
depress the lock-off button from A side to lock the
switch trigger in the OFF position.
1
► 1. Lock-off button 2. Switch trigger
To prevent the switch trigger from accidentally pulled,
the lock-off button is provided.
To start the tool, depress the lock-off button from B side
and pull the switch trigger.
Tool speed is increased by increasing pressure on the
switch trigger. Release the switch trigger to stop. After
use, always press in the lock-off button from A side.
Electric brake
This tool is equipped with an electric brake. If the tool
consistently fails to quickly stop after the switch trigger
Applications
is released, have the tool serviced at a Makita service
center.
For cutting mild
steel, stainless
steel and plastics.
For clean cuts in
ASSEMBLY
wood and plywood.
For cutting mild
steel, aluminum
and hard wood.
switched off and the battery cartridge is removed
For cutting wood
before carrying out any work on the tool.
and plywood.
For fast cutting in
Installing or removing jig saw blade
aluminum and mild
steel.
For fast cutting in
wood and plywood.
eign matter adhering to the jig saw blade and/or
blade holder. Failure to do so may cause insufficient
tightening of the blade, resulting in a serious personal
injury.
the workpiece immediately after operation. They
may be extremely hot and could burn your skin.
firmly. Insufficient tightening of the blade may cause
blade breakage or serious personal injury.
Using blades other than B type causes insufficient
tightening of the blade, resulting in a serious personal
injury.
To install the jig saw blade, loosen the bolt counter-
clockwise on the jig saw blade holder with the hex
wrench.
6 ENGLISH
1
2
B
CAUTION:
Always be sure that the tool is
CAUTION:
Always clean out all chips or for-
CAUTION:
Do not touch the jig saw blade or
CAUTION:
Always secure the jig saw blade
CAUTION:
Use only B type jig saw blades.
A