Installing Spindle Lock; Attaching The Spur Center; Attaching The Live Center - LEMAN TAB040 Manuel D'utilisation

Installing Spindle Lock

Locate the spindle lock assembly from the
carton, and install it onto the headstock with an
adjustable wrench.
Warning: Disengage the spindle lock before
turning the machine on.
Attaching Spur Center On The
Headstock
Insert spur center, with a No. 2 Morse Taper
shank, into the headstock spindle.(See Fig.03)
Knockout Bar
The knockout bar is used to remove the spur
center from the headstock spindle. Insert
knockout bar into hole at opposite side from spur
center. (See Fig.04)
Attaching Live Center On the Tailstock
Insert the live center, with a No. 2 Morse Taper
shank into the tailstock spindle. (See Fig.05)
To remove the live center from the tailstock
spindle, loosen locking arm and rotate the hand
wheel counter clockwise to retract spindle into
the body of the tailstock. The live center will be
pushed out of the spindle.
(See Fig.06)
(See Fig.02)
Spindle lock
Knockout bar
Live center
Locking arm
4
EN
Fig.02
Headstock spindle
Spur center
Fig.03
Fig.04
Locking arm
Tailstock spindle
Fig.05
Fig.06