Télécharger Imprimer la page

Worx WT155 Mode D'emploi page 12

Publicité

Les langues disponibles

Les langues disponibles

12
Cordless Drill/Drivers
NA-WT155-M-051115.indd 12
All manuals and user guides at all-guides.com
15. DISPOSAL OF AN EXHAUSTED BATTERY
PACK
To preserve natural resources, please recycle or
dispose of the battery pack properly. This battery
pack contains nickel-cadmium batteries. Consult your lo-
cal waste authority for information regarding available
recycling and/or disposal options. Discharge your bat-
tery pack by operating your drill, then remove the bat-
tery pack from the drill housing and cover the battery
pack connections with heavy duty adhesive tape to pre-
vent short circuit and energy discharge. Do not attempt
to open or remove any of the components.
WORKING HINTS FOR YOUR DRILL
1. WHY DOES THE DRILL NOT TURN ON WHEN
YOU PRESS THE SWITCH?
The forward and reverse switch, which is on top of the
trigger, is positioned in the lock function. Unlock the for-
ward and reverse switch putting it into the required rota-
tion position. Push the trigger and the drill will start to
rotate (See Fig 3).
2. THE DRILL ROTATES SLOWLY. WHY?
Verify the battery is fully charged by pressing the battery
test button. If the battery is not fully charged, recharge
the battery with the supplied battery charger (Note: Do
not charge the battery with a different charger. Charge
battery pack only with the charger provided).
3. THE DRILL STOPS BEFORE THE SCREW IS COM-
PLETELY TIGHTENED. WHY?
Verify the torque position of the torque adjusting ring,
you can find the torque adjusting ring between the chuck
and the drill body. Position 1 is the lowest torque (screw
driving force) and position 23 is the highest torque
(screw driving force). Position 24 is for drill operation.
Regulate the torque adjusting ring to a higher position
to reach the best result (See Fig 5).
4. I CANNOT FIT THE BATTERY INTO THE BAT-
TERY CHARGER. WHY?
The battery can be inserted into the charger only in one
direction.Turn the battery around until it can be inserted
into the slot, the red LED light should turn on when the
battery is charging (See Fig 1).
5. REASONS FOR DIFFERENT CHARGING TIMES.
Your charge time can be affected by many reasons, which
are not defects in your product. If the battery pack is only
WT155
2005-11-15 17:47:10

Publicité

loading