Decommissioning And Disposal; Decommissioning; Disposal - Interroll RollerDrive EC5000 AI/BI Série Notice D'utilisation

9

Decommissioning and disposal

CAUTION
Risk of injury from following incorrect procedure.
Decommissioning must only be carried out by authorised, qualified personnel.
¾
¾ Only decommission the RollerDrive when the system has been disconnected from the power supply.
Switch off the power to the RollerDrive and ensure that it cannot be unintentionally switched on again.
¾
9.1

Decommissioning

¾ Disconnect the RollerDrive cable from the control system.
¾ Remove the outer nut from the motor shaft.
If the RollerDrive is fitted with an internal thread shaft pin, remove the screw on the shaft.
¾
Remove the RollerDrive from the side profile.
¾
9.2

Disposal

The operating company is responsible for disposing of the RollerDrive according to correct procedure. In
doing so, the industry-specific and local provisions for disposing of the RollerDrive and its packaging must
be observed.
Version 2.5 (04/2020) UL
Translation of the original operating manual
Decommissioning and disposal
51 of 116