Programming The Coffee Measures (Only A Version) - Cimbali Casadio Dieci Série Utilisation Et Installation

15. Programming the coffee measures (only A version)

How to access the programming function
To enter the programming mode, press push button (18)
and keep it pressed for a few seconds; the blinking LED
light sequence above the keys and the intermittent buzzer
indicates that the machine is in the programming phase.
To exit the programming mode, after programming the
various drinks, press push button (18) again.
"Before programming the coffee dispensing
serving of ground coffee. Don't use coffee grouts
for programming servings."
unit, positioning the cup (or cups) under the nozzle (or
Press (and keep momentarily pressed) the coffee
dispensing push button (16, 17, 19 or 20) corresponding
to the required serving to be programmed; the LED of the
key to be programmed stays on and does not blink.
When the amount of coffee in the cup reaches the required
level, release the coffee dispensing push button.
Repeat the above operations for the other coffee push
buttons.
Note: if you make a programming mistake, use a new dose
of ground coffee and repeat the operation.
10) on the coffee dispenser
10).
19 20
10
11 EN
18 16 17
10