Use; Setting At Work; Cup-Warmer (When Provided); Heating Phase - Cimbali Casadio Dieci Série Utilisation Et Installation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 39
"Before setting the machine at work, make
sure that:
• the main electric power switch is on;
• the mains water cock has been turned on".
Press the luminous main switch (1) and the related
indicator light switches on. For A versions, the key LEDs
also light up.
If the water level in the boiler is lower than the minimum
restored pressure in the manometer-pump.
Press the luminous switch for resistance activation (1a);
the related indicate light switches on and the heating
phase begins.
Place only coffee cups, cups and glasses to be used in
conjunction with the coffee machine on the cup-warming
plate.
Ensure that the coffee cups are completely drained before
placing them on the cup-warming plate.
No other objects shall be placed on the cup-warming plate
(11).
Press the button (12) and check to see that the light turns on.
A version. During heating, if one of the coffee dispensing
push buttons is pressed, the machine dispenses a coffee
at the temperature reached at the time.
S version. During heating, if one of the coffee dispensing
button (2) is pressed, the machine dispenses a coffee at
the temperature reached at the time.
Heating is completed when the boiler gauge indicator (14)
remains stable in the P green area.
The machine is now ready to dispense coffee, steam and
hot water.
A version. To make sure that the dispenser unit and the
(10) are at similar temperatures, press the
coffee dispensing push button (18) and let the machine
dispense coffee for a few seconds. Then press again the
push button (18) to stop dispensing.
S version. To make sure that the dispenser unit and
(10) are at similar temperatures, press
the coffee dispensing switches (2) and let the machine
dispense coffee for a few seconds. Then press the switch
(2) to stop dispensing.

USE

10. Setting at work

Wait until the operating pressure (approx. 1.2 bar) appears
on the manometer (14).
At this point, the machine is ready for use.

11. Cup-Warmer (when provided)

12. Heating phase

9 EN
11
A
18
14
10
1
1a
ON
ON
12
S
2
14
10
P

Publicité

Table des Matières
loading

Table des Matières