Status Displays; Restoring The Factory Settings; Using The Analog Video Output - Abus TVIP31001 Manuel Utilisateur

4.7 Status displays

LED
Network
Power supply
WLAN
SD card

4.8 Restoring the factory settings

Camera restart
Restoring the factory settings

4.9 Using the analog video output

The analog video output (Video Out) can be used for
connecting an analog test monitor for configuration of
the camera module. The connection is made using a
cinch plug.
The analog video output can be activated or
deactivated in the camera configuration. The video
option for 640x480 resolution is only available when
the analog video output is deactivated.
The analog video output is activated as standard.
Color Meaning
Green Constantly green when network connection is active
Orange Flashes when network activity is detected (data traffic
active)
Red Constantly red during camera start-up; active for 30
seconds when WPS is active
Blue Constantly blue after successful camera start-up
Violet Flashes during WPS configuration or firmware update
Off When the reset button is pressed
Green Constantly green when the WLAN connection is active
Flashes when data traffic via WLAN is active
Orange Constantly lit when SD card is available
Flashes during the write process
Press the button until the blue LED goes out -> constantly red
during camera restart -> constantly blue after successful
camera restart
Press the button until the LED lights up blue constantly ->
constantly blue after successful camera restart
74