Hitachi YUTAKI S Serie Manuel D'installation page 35

TEST RUNNING
13.1. TEST RUN PROCEDURE FROM INDOOR UNIT SIDE
User could execute the test run function pressing the "OK" and down " " arrow button during 3 seconds.
After that combination, the remote control will ask about the duration of this test.
The duration will be between 00:30 and 12:00 hours.
After press start, Outdoor unit will begin with the test run.
During the execution of this test, it will be showed the following screen.
On that screen it could be cancelled the test. User could move on same screen through the "Operation display parameters" menu.
Note that when test start it will be exit from the installer mode.
When test run will be set on the outdoor unit, it will appear the test run icon on the notifications row.
When test run will finished it will show the following screen.
Pressing Accept user will go to the global view.
TEST RUN OUTDOOR UNIT
Configuration for outdoor unit test run
Duration:
CANCEL START
INSTALLER MODE
HITACHI
!
AM
PM
TEST RUN OUTDOOR UNIT
TEST RUN OUTDOOR UNIT
Pending time: 44h 20m 19s
Pending time: 44h 20m 19s CANCEL CANCEL
Operation display parameters Operation display parameters
System Operation
System Operation
Unit Status
Unit Status
Actual temperatures
Actual temperatures
Set-point
Set-point
€
T.
SUM
OFF
RUN
I II III
HITACHI
!
AM
PM
TEST RUN OUTDOOR UNIT
TEST RUN OUTDOOR UNIT
Test Run Completed Test Run Completed EXIT
EXIT
Operation display parameters Operation display parameters
System Operation System Operation
Unit Status
Unit Status
Actual temperatures
Actual temperatures
Set-point Set-point
€
T.
SUM
OFF
RUN
I II III
PMML0215A rev.1 - 02/2012
37