AL-KO GTLi 18V Mode D'emploi page 19

Maintenance and care
Always keep the guard, string head and en-
gine free of mowing debris.
Do not spray the machine with water! Pene-
trating water can lead to malfunctions.
Do not get the appliance wet or expose it to
moisture.
Regularly check the appliance is in good
working order.
Do not use any cleaning agents or solvents.
They can cause irreparable damage to the
appliance.
Changing the spool
(Replacement spool GT Li 18V art. no. 112969)
1. Press the two locking catches to open the co-
ver (8-1).
2. Remove the empty spool (8-2).
3. Insert the new spool.
4. Make sure that the spring is re-inserted (8-3).
5. Guide the line outwards on both sides.
6. Put on the cover and engage the locking cat-
ches.
STORAGE
Clean the appliance and its accessories after
each use.
Keep the appliance out of reach of children
and unauthorised persons.
TROUBLESHOOTING
Malfunction
Motor does not run
Trimmer vibrates
Battery operating time is
significantly shorter
Battery cannot be charged Charge plug or contact socket con-
440084_a
All manuals and user guides at all-guides.com
Possible cause
Motor protection switch has swit-
ched off
Flat battery
Spool is contaminated
Grass too long or too wet
Cutting height too low
Battery flat because not used for
some time
Battery service life expired
taminated
Battery or charger defective
Hang up the lawn trimmer by its handle.
This avoids placing unnecessary load on
the cutter head.
Storing the battery and charger
Store the battery in a dry place protected from
frost, with an ambient temperature between 0
°C and +35 °C, and with the battery charged
to approx. 40 - 60%
Completely recharge the battery for about 2
hours after 6 months in storage
Do not store the battery near metallic or acid-
containing objects - these present a risk of
short-circuit!
DISPOSAL
Do not dispose of old
equipment,batteries or accumulators
as householdwaste!
Product, packaging, and accessories
were made with recyclable materials, and
should be disposed of accordingly.
The user is obliged to return the batteries.
Disposal can be handled by the retailer or at
recycling centres.
Do not dispose of the battery unless it is di-
scharged.
Solution
Wait until the motor protection
switch switches the trimmer back
on.
Charge the battery
Clean the spool, renew it if ne-
cessary
Let it dry, set a higher cut
Raise the cutting height
Charge the battery
Renew the battery. Only use ge-
nuine accessories from the manu-
facturer
Order spare parts acc. to the spare
parts card
19