Publicité
Les langues disponibles
Les langues disponibles
Assembly
Incorrect use can result in fluid leaking out
of the battery. Avoid contact with the fluid. In
case of inadvertent contact, rinse off with wa-
ter. If the fluid gets into your eye, seek additio-
nal medical assistance. Leaking battery fluid
can lead to skin irritations or burns.
Each time before using the charger, check
the housing, plug and cable for damage.
Do not use the charger if it is damaged.
Do not open the charger! Renew the charger
if it is defective.
Protect the appliance, battery and charger
against moisture. Only charge indoors.
Only have electrical appliances repaired by
qualified electricians, and only using genuine
spare parts. This ensures that the appliance
remains safe.
ASSEMBLY
CAUTION!
The machine must not be put in opera-
tion before it has been assembled com-
pletely.
CAUTION!
Do not insert the battery until the appli-
ance has been completely assembled.
Install the guard plate
The knife integrated in the guard plate
automatically cuts the line to the opti-
mum length.
1. Set the guard plate in relation to the cutter
head (2-1).
2. Make sure that the line is exposed.
3. Screw the guard plate on at the rear with the
supplied screws (2-1).
4. Place the guide wheel on the guard hood and
tighten the screws (2.2).
Installation of auxiliary handle
The holder of the auxiliary handle is mounted on
the telescopic handle. The supplied replacement
spool is integrated in the holder.
Installation of auxiliary handle
The angle of the handle can be individually adjus-
ted using the tip lever.
1. Push the holder onto the shaft.
2. Pull the grip bar of the auxiliary handle slightly
apart (3-1).
440084_a
All manuals and user guides at all-guides.com
3. Push the auxiliary handle onto the holder
(3-2).
4. Engage the auxiliary handle in the splines.
5. Place the tip lever with pin holder onto the
clamping pin.
6. Screw the clamping pin tight so that the tip
lever can be operated with little force (3-3).
STARTUP
CAUTION!
Always perform a visual check prior to
start-up.
CAUTION!
Do not use damaged batteries. Danger
of fire!
CAUTION!
Danger of explosion and fire!
The charger heats up during charging.
Do not place it on a flammable surface or
in a flammable environment.
Charging the battery
The battery is supplied partially charged!
Fully charge the battery before the first
use.
The battery can be charged in any
charge level. Interrupting charging does
not damage the battery.
The battery is protected against exces-
sive charging by a supply voltage control
function, which means it can be left con-
nected to the mains for some time.
1. Connect the charger (1-5) to the mains wi-
thout the battery (1-4). The LED on the mains
adapter lights up green.
2. Connect the battery to the charger. The LED
on the mains adapter lights up red. Charging
starts.
The temperature range for charging
should be between 5 and +45 °C.
The charging time for a full charge is
max. 200 minutes. If the operating time
of the battery is significantly shorter in
spite of full charging, this indicates the
battery service life has expired and it
must be replaced by a new, genuine bat-
tery.
17
Publicité
