Black & Decker PRO Serie Mode D'emploi page 10

ENGLISH
position by pressing the rear part of the switch and
releasing. Ensure the slider switch is in the off position as
described above after any interruption in power supply to
the tool, such as the activation of a ground fault interrupter,
throwing of a circuit breaker, accidental unplugging, or
power failure. If the slider switch is locked on when the
power is connected, the tool will start unexpectedly.
To start the tool, slide the slider switch (a) toward the front of
the tool. To stop the tool, release the slider switch.For
continuous operation, slide the switch toward the front of the
tool and press the forward part of the switch inward. To stop
the tool while operating in continuous mode, press the rear
part of the slider switch and release.
Spindle lock (Fig. 1)
The spindle lock (b) prevents the output shaft from rotating
when attaching or removing the grinding wheel. Only use
the spindle lock when the tool is switched off, power is
unplugged, and wheel stops completely.
Note: To minimize tool damages, don't use the
spindle lock when the tool is operating.
Otherwise, it may damage the tool. The
attached accessories may come off and cause injury.
If using the spindle lock, press the spindle lock button and
rotate the output shaft until it stops.
Application on Metals
When applying the tool on metals, make sure that a
residual-current device (RCD) is inserted to prevent danger
from metal chips.
If the RCD causes power disconnection, have the tool sent
to an authorized Black & Decker dealer for repair.
Warning! Under extreme working conditions,
conductive dust and grit may accumulate on the
housing interior when handling metal
workpieces. This could create an electric shock hazard as it
weakens the protective insulation in the grinder.
To avoid accumulation of metal chips in the interior of the
grinder, we recommend cleaning the ventilation ducts daily.
Refer to Maintenance.
10
All manuals and user guides at all-guides.com
Using Grinding Wheels
reduce the risk, insert the RCD before use and clean the
ventilation ducts daily. Follow the maintenance instructions
below to blow dry compressed air into the ventilation ducts.
Maintenance
Black & Decker power tools have been designed to operate
over a long period of time with minimal maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
removing/installing any accessory. Before reassembling the
tool, press and release the trigger switch to make sure the
tool is already switched off.
Lubrication
This power tool does not require separate lubrication.
Cleaning
grit out of the interior of the housing. You need to wear
approved eye and facial protective gear when performing
this process.
the parts. Use only mild soap and damp cloth to clean the
tool. Never let any liquid get inside the tool; never immerse
any part of the tool into liquid.
Warning! Metal powder accumulates.
Excessive use of the grinding wheel on metals
may increase the risk of electric shock. To
Warning! To minimize the danger of serious
personal injury, please switch off the tool power
and disconnect all plugs before adjusting or
Warning! Once visible dust accumulates on the
ventilation ducts and the surrounding,
immediately use dry air to blow away dust and
Warning! Never use solvents or harsh
chemicals to clean non-metal parts of the tool.
These chemicals may weaken the material of