SOUNDMASTER ELITE Serie Mode D'emploi page 17

All manuals and user guides at all-guides.com
IR4400 / English Short Instruction Manual
The active value appears as flashing. Adjust each value with the "Tuning / Select /
Snooze" knob. Once the value is set, press the knob to continue setting with next
value.
6. Network
Keep Network connected
Select this option when the unit should the network connection in standby keep,
when the function is confirmed, the unit wills faster connecting the internet and it is
possible to switch on the unit with the "UNDOK" app.
Note: The standby power consumption is slightly increased with this function.
WLAN region
Select the WLAN region to obtain the optimal WLAN connectivity: Europe.
Scanning for the network
The unit is compatible with all common network protocols and encryption methods. It
searches for the available networks and list them out for you.
For the wireless connection, you will be asked for input the encryption in the next
step. To enter the network's key, use the "Tuning / Select / Snooze" knob to move
the cursor through the characters and select "OK" to confirm. As each character is
selected, the key is built up near the top of the display.
There are three options accessible by tuning the navigate reel back before the first
characters – "Backspace", "OK" and "Cancel".
"WPS" encrypted network
There will be hints for the type of network – if your network devices support WPS
function, it will be [WPS] before the SSID (the name of the network device). Select
the one you want to connect. Use one of the following methods of connection:
There is the shortcut WPS key on the access point.
Push button
The unit prompts you to press the connect button on the router. It then scans for a
ready Push Button Connect network and connects.
Pin
The unit generates an 8-digit code number which you enter into the wireless router,
access point, or an external registrar.
Skip WPS
Enter key as for a standard encrypted network.
For more information on setting up a WPS encrypted network, see your WPS router's
instructions.
The unit attempts to connect to the selected network.
It will show connected if the setup is successful.
If connecting fails, The unit returns to a previous
screen to try again.
Press "SELECT" to quit the setup wizard.
4