Fridja f1500 Mode D'emploi page 5

All manuals and user guides at all-guides.com
F1500 FRIDJA HIGH PRESSURE GARMENT STEAMER
The appliance must be unplugged from the power supply after use and
during any maintenance or setting up, such as cleaning, refilling tank or
attaching accessories. Avoid tilting the appliance during operation to
prevent water spillage. Never immerse the unit, power cord or plug in
water or any other types of liquid.
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities or lack of experience or
knowledge, unless they have been given supervision and instruction in the
use of the appliance by a person responsible for their safety.
Do not add chemicals or detergents (other than those officially approved
by Fridja) to the water as this may damage the appliance or make it unsafe.
Distilled or demineralised water is recommended.
Do not leave the appliance unattended whilst connected to the mains
power supply. Children should be supervised to ensure they never play
with the appliance.
Never attempt to steam clothing while it being worn. Always point the
appliance away from the body and never aim at other people or animals.
Never operate the steamer without filling the water storage tank. Always
check the water level before use and during operation.
Never fold the hose or lay it on the ground.
The steamer head and accessories will become hot during use. Do not
touch them or attempt to change the accessories until they have cooled
sufficiently. The appliance must be used on a stable heat-resistant surface.
Only move the appliance by the base unit. Do not force the wheels if they
are stuck. If this happens, turn the unit off, drain the water tank and water
reservoir before inspecting the wheels. Always allow the appliance to cool
completely and drain the water tank and water reservoir before re-filling
with water, cleaning or storing.
Do not use on suede, velvet, leather, vinyl, plastic or any steam sensitive
materials. If unsure, test first on a small, discreet part of the material.
5