DeWalt DW476 Mode D'emploi page 20

disconnect from the socket. Keep the cord away
from heat, oil and sharp edges.
18 Maintain tools with care
Keep the tools in good condition and clean for better
and safer performance. Follow the instructions for
maintenance and changing accessories. Inspect the
tool cords at regular intervals and, if damaged, have
them repaired by an authorized D
agent. Inspect the extension cords periodically and
replace them if damaged. Keep all controls dry,
clean and free from oil and grease.
19 Check for damaged parts
Before using the tool, carefully check it for damage
to ensure that it will operate properly and perform
its intended function. Check for misalignment and
seizure of moving parts, breakage of parts and any
other conditions that may affect its operation. Have
damaged guards or other defective parts repaired
or replaced as instructed.
Do not use the tool if the switch is defective.
Have the switch replaced by an authorized
D WALT repair agent.
E
20 Have your tool repaired by an authorized
D WALT repair agent
E
This Power Tool is in accordance with the
relevant safety regulations. To avoid danger,
electric appliances must only be repaired by
qualified technicians.
Additional safety rules for grinding wheels and
cutting disks
• Use fiber reinforced grinding wheels and cutting
disks in conformity with ISO 2933-1974 with a
diameter corresponding to the wheel diameter
specified in the technical data only.
Package contents
The package contains:
1 Angle Grinder
1 Guard
1 Diamond guard with dust extraction outlet
(EZWS97) (DW491K only)
1 Round handle (DW491K only)
1 Side handle
1 Two-pin spanner
1 Metal case (K-models only)
1 Instruction manual
1 Exploded drawing
15
All manuals and user guides at all-guides.com
WALT repair
E
• Check for damage to the tool, parts or accessories
which may have occurred during transport.
• Take the time to thoroughly read and understand
this manual prior to operation.
Description (fig. A)
Your D WALT Angle Grinder (with or without
E
Diamond Guard) has been designed for professional
grinding and cutting applications.
1 ON/OFF-switch
2 Unlocking switch (U.K. & France only)
2a Locking switch
3 Guard
4 Spindle lock
5 Spindle
6 Side handle
7 Top hole
8 Side holes
9 Carbon brush covers
DW478, DW492 & DW491K - Soft Start Feature
The soft start feature allows a slow speed build-up
to avoid an initial jerk when starting.
This feature is particularly useful when working in
confined spaces.
Electrical safety
The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your D WALT tool is double insulated in
E
accordance with EN 50144; therefore no
earth wire is required.
Mains plug replacement
(U.K. & Ireland only)
• Should your mains plug need replacing and you
are competent to do this, proceed as instructed
below. If you are in doubt, contact an authorized
D WALT repair agent or a qualified electrician.
E
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely; a plug
with bared copper conductors is dangerous if
engaged in a live socket outlet.
• Only fit 13 Amperes BS1363A approved plugs
fitted with the correctly rated fuse (1).
• The cable wire colours, or a letter, will be marked
at the connection points of most good quality
E N G L I S H
en - 3