Philips Sonicare FLEXCARE Mode D'emploi page 8

ENGLISH
8
All manuals and user guides at all-guides.com
Charging your Sonicare
1 Plug the charger into a live outlet.
2 Place the handle on the charger.
, The flashing light on the battery gauge indicates
that the toothbrush is charging.
Deluxe recharge gauge:
Indicates amount of charge left in battery
- 3 green LEDs: 75-100%
- 2 green LEDs: 50-74%
- 1 green LED: 25-49%
- 1 flashing yellow LED: less than 25%
Note: If the battery charge of your Sonicare is low,
you hear 3 beeps and 1 LED on the recharge gauge
flashes yellow for 30 seconds after the 2-minute
brushing cycle.
Note: To keep the battery fully charged at all times,
you may keep your Sonicare on the charger when not
in use. It takes at least 24 hours to fully charge the
battery.
Using your Sonicare
Brushing instructions
1 Wet the bristles and apply a small amount of
toothpaste.
2 Place the toothbrush bristles against the teeth
at a slight angle towards the gumline.
3 Press the power on/off button to turn on the
Sonicare.