Black & Decker LHT321 Mode D'emploi page 7

the battery release button (10) as shown in
figure c and pull battery pack out of tool.
B
c
aSSeMBly InSTrucTIonS
warnInG:
Make certain the battery
is removed before assembly or
disassembly of any parts.
aSSeMBly ToolS reQuIred (noT
SuPPlIed):
- Phillips Screwdriver
aTTacHInG Guard and BaIl Handle
To TrIMMer
warnInG:
only use with handle and
guard properly assembled to hedge
trimmer. The use of the hedge trimmer
without the proper guard or handle provided
may result in serious personal injury.
The trimmer is shipped with the guard and
bail handle attached to the trimmer with a
plastic zip tie.
To assemble to trimmer:
• Cut the plastic zip tie.
• Remove the six screws that are partially
run into the trimmer housing (figure d).
d
All manuals and user guides at all-guides.com
• Slide the guard (5) onto the front of the
• Insert two of the six screws into the
10
• Slide the bail handle (6) onto the front of
• Insert the remaining four screws into the
oPeraTIon
SwITcH
• To turn the unit on, push the lock off
• To turn the unit off, release the trigger.
LOCk A SwITCH IN THE ON POSITION.
7
trimmer housing as shown in figure e.
openings on the sides of the guard and
tighten securely.
e
the trimmer housing behind the guard as
shown in figure f.
openings on the sides of the bail handle
and tighten securely.
f
button (2) down and squeeze the trigger
(1), as shown in figure G. Once the unit
is running, you may release the lock-off
button. In order to keep the unit running
you must continue to squeeze the trigger.
warnInG:
NEVER ATTEMPT TO
G