Télécharger Imprimer la page

RECARO Young Profi plus Notice De Montage Et D'utilisation page 14

Masquer les pouces Voir aussi pour Young Profi plus:

Publicité

6.4
1
A
7
sto2773-4-11/1 disk STM RECARO Young Profi plus, Bild 4.4 Montageanlei
2
6.4 Beim Transport im Fahr-
zeug muss der Tragebügel
aufrecht stehen.
6.4 During transportation in
the vehicle, the carrying
handle must be in the upright
position.
7. Ausbau der Babyschale:
Drücken Sie den Entriegel-
ungshebel (A) für die vorde-
ren Einrastungen und heben
Sie die Babyschale an. Die
Babyschale etwas nach hin-
ten drücken und nach oben
3988F-4-00/1
heraus nehmen. Sollte dies
auf Grund Ihres Fahrzeugpol-
sters schwierig sein, verstellen
Sie die Plattform etwas nach
vorne, siehe Bild 8.1.
7. Removing the infant carrier:
Press down the locking lever
(A) to release the front locks
3
and lift off the infant carrier.
Push the infant carrier slightly
towards the rear of the
vehicle and lift out. If this
proves to be difficult on
account of collision with the
vehicle's rear seat, then
readjust the Isofix base slightly
3987F-4-00/1
forwards (see fig. 8.1).
D
GB
2773-4-11/1

Publicité

loading