Inakustik HDMI Matrix Mode D'emploi page 18

OPERATING MANUAL
The procedure is a cyclic function
When you selected the channel, there will be a LED on to present the channel. If you select channel
1, the CH1 LED will light on.
Reset:
-

TROUBLE SHOOTING
1. When there is no picture presented, please:
Make sure the direct connection from the source device to the display device without the HDMI

Switcher is working.
Check all connectors connect well or not.

Check the connecting cable is damaged or not.

Check the power of HDMI matrix switcher (or reset the matrix switcher)

2. When there is only picture displayed and without sound:
Check the cable connection to see if it fits properly.

Check your cable to see if it supports video transmission only (DVI) or it is damaged.

HDCP may not match very well at first connection; please reset your HDMI matrix switcher.

Do you connect any output to your video recorder? HDCP will lock up audio part.

3. When use a coaxial/optical audio cable to connect the matrix switcher to a Home Theater System, no
sound is delivered by the Home Theater System.
Please check the connection.

The coaxial/optical audio cable needs to be connected to the coaxial/optical audio input port of the

Home Theater System.
The audio input selection of the Home Theater System needs to be selected to a corresponding

coaxial/optical audio input.
Please make sure the output audio format can be supported by the Home Theater System. If the

audio format is in Dolby® or DTS® format, the Home Theater needs to support Dolby® or DTS®
decoding.
4. When use a coaxial/optical audio cable to connect the matrix switcher to a Home Theater System, the
coaxial/optical audio output only delivers stereo audio signal to the Home Theater System.
Because the HDTV (or Projector) which connected to the Output-A can only support stereo audio

signal, the coaxial/optical audio output will send out the audio signal based on the Output A.
Please refer to the page 3 for audio output format adjustment.

5. When resolution could not show in 1080p.
Make sure your sources and displays are fully supporting 1080p.

Make sure your HDMI cables are capable of transmitting 1080P video signal.

6. When 4K2K & 3D content could not be shown on your display.
Please make sure your sources and displays are 4K2K & 3D supported devices and also support

the same 4K2K & 3D format.
Please check the play mode of Blue-ray player has been set 4K2K & 3D mode or AUTO mode for

video output.
Please make sure the video content is 4K2K & 3D content.

7. If the presented picture is not a proper 4K2K & 3D image, please check whether the 4K2K & 3D
format of your sources (Blue-ray player, PS3, etc.) and displays (TV or projector) are correct setting.
8. If the presented picture is symmetric, which showed with up and down or right and left symmetric
18
image, please check whether the TV or projector supports 4K2K & 3D display function and make sure
the function is enabled. If the TV or projector does not support 4K2K & 3D video format, please turn
off the 4K2K & 3D play mode of sources.
Use the Reset key on the back of the Matrix Switcher to reset the HDMI Matrix Switcher to the
initial status.