Inakustik HDMI Matrix Mode D'emploi page 14

OPERATING MANUAL
2. TOSLINK OR COAXIAL DIGITAL AUDIO TO AMPLIFIER
3.
NOTE
If you want to select or distribute 4K2K & 3D source to either one or two of the displays, please
-
make sure all of the sink devices support the same HDMI 4K2K & 3D video format as the source.
The 4K2K & 3D image cannot be delivered to TVs which do not support 4K2K & 3D video format.
Output-A supports an unmodified SPDIF (coaxial/optical) digital audio output. Users can use it to
-
connect to a Home Theater system which supports a coaxial/optical digital audio input.
The output of the SPDIF (coaxial/optical) digital audio format is based on the HDMI Output-A. If
-
the sink devices (HDTV or Projector), which connected to Output A and Output B, can only
support stereo audio, the coaxial/optical digital audio may also send out PCM stereo audio.
- For audio output format adjustment: (Please refer to the source device manual.)
1. Check the supported audio format of the feature film. (Stereo, DTS® 5.1, and Dolby® Digital
5.1...etc)
2. Set the audio output format of source device. Ex. uncompressed PCM or Bit Stream (Dolby®
Digital 5.1, DTS® 5.1 ...etc.)
3. Select the output of audio format and language from the main feature menu.
For HD quality audio (Dolby® TrueHD, DTS-HD Master AudioTM), or other audio formats that
-
need high bandwidth for audio transmission, please use HDMI connection for the HD audio
transmission.
If the output audio format is not supported by the sink device (HDTV, Home Theater receiver,
-
Sound Bar Speaker), you may hear noise form the speakers or you will not hear any sound from
14
the speakers.
If you want to use a Home Theater System or other speaker system for audio output, it is
-
recommended to mute the audio speaker of the HDTV.
It is recommended all the connected sink devices (HDTV, Projector, Home Theater Receiver...etc.) and
-
source devices (Blue-ray Player, PS3...etc.) support the same highest resolution, color deep and audio
format.