Manual Operation - Inakustik HDMI Matrix Mode D'emploi

HDMI 4K2K & 3D VIDEO FORMAT
Frame packing
1920x1080p@23.98/24Hz
1280x720p@59.94/60Hz
1280x720p@50Hz
NOTICE
1. If one of the sink devices does not support the highest video format of the other one, the device with
lower video format will show no image.
2. If one of the sink devices does not support the highest audio format of the other one, the device with
lower audio format will become soundless.
3. If one of the sink devices does not support the highest format of the other one, the device with lower
format will either have no picture or no sound presented.
4. Please make sure the setting of the source device can be supported by the amplifier.
5. If the other sink device of Output B does not support the output standard of Output A, the sink device
of Output B will be displayed either without picture or without sound.
IR REMOTE OPERATION
Two sets of power and selection keys are available for Output A and
-
Output B. The power and selection of Output A and Output B can be
controlled individually.
Output A:
-
Use the power key of Output A on the IR remote controller to turn

on the signal transmission of Output A. The power indication LED
(Active-A) of Output A on the front panel will be lighted on. Press
the power key of Output A one more time to turn the Output A to
standby.
Use number keys to switch between sources.

Output B:
-
Use the power key of Output B on the IR remote controller to turn

on the signal transmission of Output B. The power indication LED
(Active-B) of Output B on the front panel will be lighted on. Press
the power key of Output B one more time to turn the Output B to
standby.
Use number keys to switch between sources.

Reset:
-
Use the Reset key on the IR remote controller to reset the HDMI Matrix

Switcher to the initial status.

MANUAL OPERATION

Output A and Output B have individual source selection and power control key.
-
Output A:
-
The "Select/Power" key is a multi-function key.

Power Control: Press the "Select/Power" key for 2 seconds to turn off the power (Standby);

press the "Select/Power" key once to turn on the switcher.
Source Selection: If you want to change the input channel manually, you can press the

"Select/Power" key once. A LED will be lighted up for the channel indication.
Output B:
-
The "Select/Power" key is a multi-function key.

Power Control: Press the button for 2 seconds to turn off the power (Standby); press the

"Select/Power" key once to turn on the switcher.
Source Selection: If you want to change the input channel manually, you can press the

"Select/Power" key once. A LED will be lighted up for the channel indication.
Side-by-Side (Half)
1920x1080i@59.94/60Hz
1920x1080i@50Hz
MODE D'EMPLOI
OPERATING MANUAL
Top-and-Bottom
1920x1080p@23.98/24Hz
1280x720p@59.94/60Hz
1280x720p@50Hz
4K2K
4096x2160@23.98/24Hz
3840x2160@23.98/24Hz
17