Publicité
Les langues disponibles
Les langues disponibles
3. Assembly
3.1. Headlight assembly
The scooter's headlights are installed in the position shown below by
default.
In order to install the headlights in the correct position, first loosen
the screws marked as number 6 and remove them. Then, use 4 M6*16
hexagonal screws and the 4 flanged lock nuts to fix the headlight bracket
and mount the headlights on it as shown on the picture.
Note: Some of the headlight parts have no use and must be removed.
Please remove the parts shown on the picture below:
3.2. License plate bracket with light assembly
To install the license plate bracket, add a bushing a change both screws.
Change both screw marked as 7 and 8 with 2 M6*30 hexagonal screws.
Then, connect the cable of the license bracket's light to the cable coming
from the scooter's board.
3.3. Rear-view mirror assembly
To install the rear-view mirrors, just insert them in the
holes located on the handlebar and screw them tight-
ly. Once they have been screwed, cover the lower part
with the trim.
3.4. Speedometer assembly
To install the speedometer, first assemble the speedometer bracket
onto the handlebar. To do so, screw 2 M6*10 hexagonal cap head
screws onto the 2 threaded holes on the back of the handlebar as
shown on the picture.
Then, use 2 M4*10 hexagonal cap head screws to fix the
speedometer onto the speedometer bracket.
38
All manuals and user guides at all-guides.com
Finally, connect the speedometer cable to the cable on the scooter's stem.
5. OPERATION
BATTERY CHARGING
NOTE: make sure the device is turned off.
1.
2.
NOTE:
•
•
•
Open the charging port's (1) cover located on the right side of the vehicle and insert the
3-contact power adapter's end.
Connect the other power adapter's end to a wall power supply. The light indicator will
turn red during charge and will turn green when fully charged.
1
The device comes already charged, but it is recommended to charge it for 6-8 hours
before the first use.
It is also recommended to charge it after each use and before storing it.
To avoid the battery from damaging, do not allow the vehicle to fully discharge.
39
Publicité
