cecotec Outsider DemiGod Makalu Mode D'emploi page 18

2. Repeat the before step with the
right grip (the one with the throttle).
ADJUSTING THE HANDLEBAR'S HEIGHT
1. Turn the height-adjustment wheel anticlockwise and raise or lower the handlebar stem.
2. Once it is adjusted to the desired height, turn the wheel clockwise to fix it. Make sure the
handlebar is tight.
ACCESSING AND ACTIVATING THE BATTERY AND ENGINE
The battery and engine are already installed and connected. To access to any of these, lift the
board. To activate the electric circuit, insert the fuse supplied.
34
All manuals and user guides at all-guides.com
ASSEMBLING THE SADDLE
1.
2.
3.
4.
ADJUSTING THE FRONT AND REAR BRAKE
Both brakes require periodic adjustment.
•
•
•
•
Pass the seat post through the hole in the table and align it with the corresponding
screws on the main body.
When aligned, secure the seat post with nuts, one on each side.
Next, run the rear seatlight cable through the inside of the saddle and tighten it with the
clamps.
Finally, attach the saddle to the seat post.
The brake must be at a 5 or 6-mm distance from the handlebar grip.
Place yourself on the vehicle to verify the distance between the handlebar grip and the
brake.
If the distance exceeds the recommended one, turn the washer on the brake (A) to adjust
it.
To adjust the brake cable's tension, adjust the screw (B) on the rear wheel. This will allow
the wheel to spin freely when the brake is not operated and will allow the vehicle to stop
immediately when it is pressed.
A
B
35