Black & Decker EGBL148 Mode D'emploi page 9

Drilling in masonry (fig. D & E)
• For drilling in masonry, set the collar (3)
to the hammer drilling position by
aligning the symbol
• Slide the speed selector (5) towards the
front of the tool (2nd gear).
Speed selector (fig. E)
• For drilling in steel and for screwdriving
applications, slide the speed selector (5)
towards the rear of the tool (1st gear).
• For drilling in materials other than steel,
slide the speed selector (5) towards the
front of the tool (2nd gear).
Drilling/screwdriving
• Select forward or reverse rotation using
the forward/reverse slider (2).
• To switch the tool on, press the switch
(1). The tool speed depends on how far
you press the switch.
• To switch the tool off, release the switch.
Hints for optimum use
Drilling
• Always apply a light pressure in a
straight line with the drill bit.
• Just before the drill tip breaks through
the other side of the workpiece, decrease
pressure on the tool.
• Use a block of wood to back up
workpieces that may splinter.
• Use spade bits when drilling large
diameter holes in wood.
• Use HSS drill bits when drilling in metal.
• Use masonry bits when drilling in soft
masonry.
• Use a lubricant when drilling metals
other than cast iron and brass.
• Make an indentation using a centre
punch at the centre of the hole to be
drilled in order to improve accuracy.
(Original instructions)
with the marking.
Screwdriving
• Always use the correct type and size of
screwdriver bit.
• If screws are difficult to tighten, try
applying a small amount of washing liquid
or soap as a lubricant.
• Always hold the tool and screwdriver bit
in a straight line with the screw.
Maintenance
Your BLACK+DECKER tool has been
designed to operate over a long period of
time with a minimum of maintenance.
Continuous satisfactory operation depends
upon proper tool care and regular cleaning.
Your charger does not require any
maintenance apart from regular cleaning.
Warning! Before performing any
maintenance on the tool, remove the battery
from the tool. Unplug the charger before
cleaning it.
• Regularly clean the ventilation slots in
your tool and charger using a soft brush
or dry cloth.
• Regularly clean the motor housing using
a damp cloth. Do not use any abrasive or
solvent-based cleaner.
• Regularly open the chuck and tap it to
remove any dust from the interior.
Batteries
BLACK+DECKER batteries can be
recharged many times. At the end of
their useful life, discard batteries with
due care for our environment:
• Run the battery down completely, then
remove it from the tool.
• NiCd, NiMH and Li-Ion batteries are
recyclable. Take them to any authorised
repair agent or a local recycling station.
ENGLISH
9