Lenze HMI EPM-H521 Instructions De Mise En Service page 52

1 Preface and general information
About these Operating Instructions
1 Preface and general information
This EPM-H521 operating unit enables you to access codes of Lenze controllers and
to control them easily. Communication takes places via the system bus (CAN).
The Lenze software »HMI Designer« is a powerful development tool for creating
projects containing the configuration of the operating unit.
1.1 About these Operating Instructions
These Operating Instructions describe safe and trouble-free working on and
ƒ
with the EPM-H521 operating unit.
All persons working on and with the EPM-H521 operating unit must have
ƒ
these Operating Instructions available and observe all relevant information
and notes.
These Operating Instructions must always be kept as a complete document
ƒ
and in a readable state.
1.2 Terminology used
Term
Drive controller
HMI
1.3 Scope of supply
Quantity
1 EPM-H521 operating unit 5
1 Operating Instructions
10 mounting clamps 10 mounting clamps
10 screws M4 × 35 mm 10 screws M4 × 35 mm
1 4 pole terminal strip for connection of DC 1 4-pole terminal strip for connection of DC
voltage supply l
1 5-pole terminal strip for system bus (CAN) 1 5-pole terminal strip for system bus (CAN)
connection connection
52
Used in this text for
Lenze frequency inverter 8200 vector and 9300 vector, servo inverter
9300 and 9400
Human Machine Interface
ope at g u t
l
Important
After receipt of the delivery, immediately check whether te ece pt o t e de e y,
the items delivered match the accompanying papers. th it d li d t h th
Lenze does not accept any liability for deficiencies Lenze does not accept any liability for deficiencies
claimed subsequently. claimed subsequently.
Claim
visible transport damage immediately to the visible transport damage immediately to the
forwarder. forwarder.
visible deficiencies/incompleteness immediately to visible deficiencies/incompleteness immediately to
your Lenze representative. i
ed ate y c ec et e
i
EDBPM-H521 DE/EN/FR 2.0