Publicité
Les langues disponibles
Les langues disponibles
Other Information
Symptom
Can't select Dolby Pro
Logic llx mode.
Can't select NEO:6
mode.
There is no sound
when playing a DTS
encoded DVD.
Heat protection
•
The protection function will come on if the main unit or power transformer overheats.
"
" will appear in the display .
This function will come on :
- If speaker terminal is shorted
- If speaker cable is shorted
If there is no problem when you turn the unit on again after turning it off, PROTECTION mark will
disappear on the display and the unit will work properly.
Error No.
E02 NO MIC
E03 NOISY
E04 MIC LEVL
E05 NO FRONT
E07 LEVL OVR
E08 DIST OVR
E13 TIME OVR
E14 CODE ERR
56
English
HW-D600_D650S_XAC_0614.indd 56
HW-D600_D650S_XAC_0614.indd 56
All manuals and user guides at all-guides.com
Check
• Is the input signal selected
properly?
• Is the input signal selected
properly?
• Is Digital input selected?
Product Protection Function
Auto Calibration Error List
Auto Calibration Error Message on OSD
Connect the calibration microphone.
Keep quiet during the measurement.
The speaker are too close to the microphone.
Install all speakers and the calibration microphone at the proper location.
Connect the front speaker correctly.
Install all speakers and the calibration microphone at the proper location.
Some speakers are too far from calibration microphone.
Install all speakers and the calibration microphone at the proper location.
Unplug and re-plug the power cable.
Then, perfrom the measurement again.
Unplug and re-plug the power cable.
Then, perfrom the measurement again.
Remedy
• Only 2 channel signal can
select Dolby Pro Logic IIx
mode. (ex:Dolby Digital, PCM,
2 channel analog input signal.)
• Use PCM and Analog input
signal.
• Check whether the DVD player
is properly connected and refer
to page 28 to select the digital
input.
2011-06-17
2011-06-17
10:35:32
10:35:32
Publicité
