Publicité
Les langues disponibles
Les langues disponibles
necessary adjust the feet by removing the
spacer (1).
Location
The appliance should be installed well away
from sources of heat such as radiators, boil-
ers, direct sunlight etc. Ensure that air can
circulate freely around the back of the cabi-
net. To ensure best performance, if the ap-
pliance is positioned below an overhanging
wall unit, the minimum distance between the
top of the cabinet and the wall unit must be
at least 100 mm . Ideally, however, the ap-
pliance should not be positioned below over-
hanging wall units. Accurate levelling is en-
sured by one or more adjustable feet at the
base of the cabinet.
If the cabinet is placed in a corner and the
side with the hinges facing the wall, the dis-
tance between the wall and the cabinet must
be at least 10 mm to allow the door to open
enough so that the shelves can be removed.
Warning! It must be possible to
disconnect the appliance from the mains
power supply; the plug must therefore
be easily accessible after installation.
All manuals and user guides at all-guides.com
1
2
Door reversibility
Important! To carry out the following
operations, we suggest that this be made
with another person that will keep a firm hold
on the doors of the appliance during the
operations.
To change the opening direction of the door,
do these steps:
1. Remove the plug from the power socket.
2. Tilt back the appliance carefully so that
the compressor cannot touch the floor.
3. Unscrew the adjustable feet, situated on
both sides at the front .
4. Remove the lower door hinge by un-
screwing the 2 retaining screws.
5. Remove the hinge pin from the bottom
of the door.
electrolux 45
Publicité
