Publicité
Les langues disponibles
Les langues disponibles
N
1 ] Run house power cable between service panel and hood location . Run the house power cable
2 ] Hang hood from (4) mounting screws previously installed . Slide hood back towards wall until
3 ] Connect ductwork to hood and use metal foil duct tape to make joints secure and air-tight .
18
Install the Hood (Standard Installation)
OTE:
Two installers are recommended because of the weight of this hood.
into the hood through the strain relief previously installed in step 6 on page 10 .
mounting screw heads are engaged in narrow end of keyhole slots in top of hood . While
holding the hood, tighten screws securely . Attach power cable to the hood using the strain
relief .
Make sure the damper assembly (or round duct plate) enters the ductwork and that the
damper opens and closes freely .
HD0921
DUCTED INSTALLATION ONLY
Publicité
