Publicité
Les langues disponibles
Les langues disponibles
FRAMELESS CABINET
HR0108A
14
HA0114
Refer to the marking on brackets to determine the correct installation side and orientation .
7/64"
Align the corresponding bracket to the cabinet side, while placing rear end of bracket
against the wall . Draw a line on the outer edge of the bracket (as shown) .
Slide the bracket towards the center of cabinet and align side edge to marked line,
keeping the rear end edge leaning on the wall .
Use a pencil to mark 3 holes .
Remove the bracket . Using a 7/64" drill bit, drill 3 holes where marked .
Assemble the bracket to the cabinet bottom using a Phillips screwdriver and 3 provided
countersunk wood screws . Repeat for the other cabinet side .
3 X
Publicité
