Kohler K-110 Instructions D'installation page 10

Install the Anchors
Anchor Hole
Anchor Channel
Loop
Strap
Loop
7. Wall-Mount Support Installation
Pivot the metal anchor channel so the plastic straps touch.
Insert the channel into the 1/2" (1.3 cm) hole in the finished wall.
Pull on the strap ring until the metal anchor channel is flush on
the inside of the finished wall.
Slide the plastic cap along the straps until it is flush with the
wall.
Break the straps off flush with the finished wall.
Insert the screw through the support flange.
Thread the screw and support flange into the anchor. Securely
hand tighten.
Loosely thread the support bolt completely into the support
flange.
1008209-2-G
All manuals and user guides at all-guides.com
Anchor
Support
Clip
Flange
10
Screw
Support
Bolt
Kohler Co.