Ismatec REGLO-Z Mode D'emploi page 15

Masquer les pouces Voir aussi pour REGLO-Z:
Table des Matières

Publicité

Digitale Eingänge (TTL-Pegel)
Digital inputs (TTL-level)
Entrées numériques (niveau TTL)
Pin 2, remote
Pin 3, start
Pin 13, internal speed
Analog-Eingang
Analog input/ Entrée analogique
Pin 5, speed IN
0–5 V
/ 0–10 V
/0–20 mA / 4–20 mA
DC
DC
Analog-Ausgang
Analog output
Sortie analogique
Pin 9, speed OUT
0–10 kHz
ISMATEC SA/REGLO-Z/-ZS/24.04.02/CB/GB
Analogschnittstelle
Pin 7, +22V
DC
Es stehen ca. +22 V
zur Verfügung
DC
(max. Strom 0.2 A).
Pin 9, speed OUT
0–10 kHz
Frequenz proportional zur
Drehzahl: 0–5000 min
–1
.
Pin 10, +5V
DC
Es stehen ca. +5 V
zur Verfügung.
DC
(max. Strom 0.1 A)
Pin 13, internal speed
Analogschnittstelle aktiviert
(Pin 2 auf GND)
– Pin 13 offen: Die Drehzahl wird
über Pin 5 (speed IN) vorgegeben.
– Pin 13 auf GND: Die Drehzahl
kann am Bedienungspanel der
Pumpe eingestellt werden.
Analog interface
Pin 7, +22V
DC
About +22 V
are available (max.
DC
current 0.2 A).
Pin 9, speed OUT
0–10 kHz
Frequency proportional to the
rotation speed: 0–5000 rpm
Pin 10, +5V
DC
About +5 V
are available.
DC
(max. current 0.1 A)
Pin 13, internal speed
Analog interface activated
(Pin 2 on GND)
– Pin 13 open: The rotation speed is
adjusted via pin 5 (speed IN).
– Pin 13 on GND:The rotation speed
can be adjuste by the speed
selector on the control panel of
the pump.
Interface analogique
Pin 7, +22V
DC
Environ +22 V
sont à disposition
DC
(courant maximal 0.2 A).
Pin 9, speed OUT
0–10 kHz
Fréquence proportionelle au nombre
de tours: 0–5000 t/min
Pin 10, +5V
DC
Environ +5 V
sont à disposition
DC
(courant maximal 0.1 A)
Pin 13, internal speed
Interface analogique activée
(Pin 2 sur GND)
– Pin 13 ouvert: La vitesse de
rotation doit être ajustée par le
pin 5 (speed IN).
– Pin 13 sur GND: La vitesse de
rotation peut être ajustée par le
sélecteur de vitesse sur le tableau
de commande de la pompe.
15

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Reglo-zsIsm 895Ism 896

Table des Matières