Publicité
Les langues disponibles
Les langues disponibles
The piston can be returned to the correct position by
pressing the reset button. Nails can then be driven. In
exceptional cases, the tool may fire without driving a nail
when the tool is actuated for the first time after it has
been reset.
1. Press the reset button (the direction of movement is
downwards at a slight angle).
7.6 Unloading the tool
1. Open the cover of the gas can compartment.
2. Release the gas can by pressing the valve head in the
direction of the arrow.
3. Remove the gas can from the compartment.
-CAUTION-
Once the valve head has been fitted to the valve seat
on the gas can it should not be removed (except when
the can is disposed of). Place the gas can complete
with valve head in the toolbox.
4. Close the cover of the gas can compartment.
5. Pull the nail pusher back until it engages.
-NOTE-
Ensure that the nail pusher engages.
6. Remove the nails from the magazine.
7. Disengage the nail pusher at the magazine and allow
it to slide forward slowly.
7.7 Application guidelines
For more detailed information, please ask the Hilti mar-
keting organization in your country for a copy of the Hilti
Fastening Technology Manual or the applicable national
regulations.
Printed: 07.07.2013 | Doc-Nr: PUB / 5069872 / 000 / 00
Concrete
A = min. distance from edge
B = min. fastener center spacing = 80 mm (3
C = min. base material thickness = 100 mm (4")
B
Steel
A = min. distance from edge
B = min. fastener center spacing = 20 mm (
C = min. base material thickness = 4 mm (
B
")
= 70 mm (2
3
/
4
")
1
/
8
A
ET C
")
= 15 mm (
5
/
8
")
3
/
4
")
5
/
32
A
C
19
en
Publicité
