Linkoln Electric Magnum PRO 100SG Manuel De L'opérateur page 8

MAGNUM PRO 100SG
SAFETY PRECAUTIONS
WARNING
ELECTRIC SHOCK can kill.
• Turn the input power OFF at the welding
power source before installation or
changing drive rolls and/or guides.
• Do not touch electrically live parts.
• When inching with the gun trigger, electrode and drive
mechanism are "hot" to work and ground and could
remain energized several seconds after the gun trigger
is released.
WARNING
WELDING MACHINES
• Read and understand the welding
machine's instruction manual and all
hazard warnings on equipment and in the
manual.
• Wear the proper personal protective
equipment for welding, including but not limited to,
safety glasses, hearing protection, welding helmet,
welding gloves, and welding leathers.
WARNING
Spool Gun
ELECTRIC SHOCK can kill.
• The spool of wire may fall out of the gun
if the locking knob is not installed.
• Metal parts may be at welding voltage
(electrically "hot").
• Metal parts remain at welding voltage for several
seconds after trigger is released. Read warning label on
gun.
• This product shall not be used in precipitation, or in wet
or damp locations.
lOCaTINg COMPONENTS aND FEaTURES
(See Figure 1.A for Items 1 thru 6)
1. Gas Cone Assembly and Contact Tip.
2. Straightened Gun Tube Assembly.
3. 1/4-Turn Locking Collar.
4. Trigger Assembly.
5. Spool Cover: Provides easy, wide-open access to spool and
wire drive.
FIGURE A.1
6. Locking Knob: Captive in spool cover.
3
2
1
4
(See Figure A.2 for these following items)
7. Integrated Single-Piece Cable: The Magnum® design
provides neat and clean appearance; simplifies cable
management and reduces entanglements.
8. Standard Durable Strain Relief Clamp.
FIGURE A.2
9. Three Captive Hex Nuts.
8
7
A-2
INSTALLATION
6
5
9