Linkoln Electric Magnum PRO 100SG Manuel De L'opérateur page 12

MAGNUM PRO 100SG
11. Grasp the free end of the wire at the gas diffuser and slowly
pull approximately 12 to 24 inches of wire through the spool
gun. There should only be 1 to 2 lbs. of resistance. If force is
greater than 2 lbs. wire is binding in the gun (also see
FIGURE A.16
Troubleshooting guide).
12. Cut off excess wire 1 to 2 inches from gas diffuser. Install
properly-sized contact tip slightly past hand-tight. Install gas
FIGURE A.17
cone and hand-tighten.
13. Reinstall spool cover. 1: tuck cover's tab in place at arrow and
hold with thumb. 2: swing cover closed. 3: finger-tighten
FIGURE A.18
locking knob. 4: check for uniform fit all around cover.
4
1
CONNECTINg ThE gUN TO ThE WElDINg MaChINE
1. Disconnect input power to the machine.
2. Make sure that the wire-drive thumb screw is loosened.
3. Fully insert gun cable connection into machine. Connect 8 pin
trigger connector to case front.
4. Check that the cable connector's end is fully inserted and
tighten the wire drive thumb screw.
3
2
A-6
INSTALLATION