Linkoln Electric Magnum PRO 100SG Manuel De L'opérateur page 11

MAGNUM PRO 100SG
4. Extend approximately 12 inches of wire from spool. Straighten
it out by back-bending it. Use care to prevent the wire from
FIGURE A.8
dereeling.
12" (30 cm)
FIGURE A.9
5. Cut off bent end of wire, leaving straight section.
12" (30 cm)
6. Gently pull open the idle roll assembly to expose the drive roll
FIGURE A.10
groove.
7. Guide straightened wire through inlet wire guide and toward
FIGURE A.11
drive roll groove.
8. While holding open the idle roll, slide end of wire through
FIGURE A.12
drive roll's groove and toward gun tube liner.
9. Slide the wire into the liner until it extends approximately 1 inch
beyond the end of the gas diffuser. Release idle roll tab without
FIGURE A.13
snapping it.
10a. Alloy 4043: Roll up remaining wire back onto spool and place
spool onto gun spindle. Install locking knob and finger-
tighten. Go to step 11.
10b. Alloy 5356: Install Conical Spring, small end first, onto gun
spindle (A). Roll up remaining wire back onto spool and place
spool onto gun spindle. Install locking knob and finger-
FIGURE A.15
tighten.
A-5
INSTALLATION
For Alloy 5356,
install conical
spring. Not needed
for Alloy 4043
A