Klein Tools IR3000 Mode D'emploi page 2

ENGLISH
Instruction Manual
GENERAL SPECIFICATIONS
The Klein Tools IR3000 is a professional series infrared thermometer. It
features a wide measurement range, a tight distance-to-spot ratio, a K-type
thermocouple input, dual lasers, and several calculation modes to assist
you in making the best possible measurements.
• Operating Altitude: 3000 meters
• Relative Humidity: 10~90%, non-condensing
•
Operating Temperature:
• Storage Temperature:
• Measurement Range:
• 0.10~1.00 adjustable
Emissivity:
• Optical Resolution (Distance: Spot):
• Dimensions: 4.7 x 1.87 x 6.76"
• Weight: 9.0 oz.
• 2 x AAA alkaline batteries
Battery Type:
• Battery Life: 180 hours typical; 140 hours minimum with continuous
use (alkaline batteries, without laser and backlight)
• Display Resolution: 0.1°~1.0°
• Calibration: Accurate for one year
• Laser: FDA and IEC Class II
• Less than 1mW
Max Output:
• Wavelength: 635~660nm
• Compliance: 21 CFR, Chapter 1, Subchapter J
• CE and RoHS
Certifi cations:
To ensure safe operation and service of the tester, follow these instructions.
Failure to observe these warnings can result in severe injury or death.
• Do not direct laser beam into eyes, as this can cause permanent
eye damage.
• Do not use the instrument if the case is damaged in any way.
• Replace the batteries as soon as low battery indicator appears.
• Have the instrument serviced immediately if it is acting abnormally.
• Be cautious of readings of refl ective materials as they may be
indicated by the instrument as cooler than they actually are
(see Emissivity section). Emissivity section). Emissivity
• Avoid using the instrument around strong electromagnetic fi elds.
• Do not apply voltage to the thermocouple probe.
SAFE PRACTICES
This instrument is designed for professionals who know the hazards
associated with their trade. While this instrument offers no foreseeable
dangers beyond its laser sight, the equipment you are servicing, as well
as the environment you're working in, can be hazardous. These are a few
common safety practices for those working around temperature critical
environments:
• Follow the manufacturer's maintenance procedures when
servicing equipment.
• Before using this instrument to determine if an area is safe to touch
or enter, verify your readings are reasonably accurate by comparison
with known measurements.
• Properly maintain your infrared thermometer and calibrate
it regularly.
IR3000
32~122°F (0~50°C)
14~140°F (-10~60°C)
-76~1400°F (-60~760°C)
30:1
WARNINGS