Junker JR48IT14 Notice D'utilisation page 26

Getting to know your appliance
en
*Getting to know your
appliance
T he instruction manual is the same for various different
G e t t i n g t o k n o w y o u r a p p l i a n c e
hobs. You can find the hob dimensions in the overview
of models. ~ Page 2
The control panel
Displays
Heat settings
‚ - Š
Residual heat
• / œ
PowerBoost function
›
Timer
‰‰
Controls
Primary switch
#
Wipe protection/child safety lock
Î
PowerBoost function
h
Hotplate selection
g
Control panel
A@
Automatic zone control
}
Timer
0
Notes
When you touch a symbol, the respective function is
■
activated.
Always keep the controls dry. Moisture reduces their
■
effectiveness.
Do not pull pans close to the displays and sensors.
■
The electronics could overheat.
The hotplates
Hotplate
Single-circuit hot-
$
plate
Dual-circuit hotplate
ð
26
Activating and deactivating
Select the hotplate and touch the
} symbol
Hotplate
Dual-circuit hotplate,
â
hotplate with
extended cooking
zone
When the hotplate is activated: the corresponding indicator lights up
Notes
Any dark areas in the glow pattern of the hotplate
■
are due to technical reasons. The function of the
hotplate is not affected.
Hotplate temperature is regulated by the heat
■
switching on and off.The heat may also switch on
and off at the highest setting.
This ensures e.g.:
– sensitive components are protected from
overheating
– the appliance is protected from electrical
overload
– better cooking results are achieved
With multi-circuit hotplates the heater elements of the
■
inner filament circuits and the heater element of the
activations may switch on and off at different times.
Residual heat indicator
The hob has a two-stage residual heat indicator for
each hotplate.
If appears in the display the hob is still hot. It may be
•
used, for example, to keep a small meal warm or to
melt cooking chocolate. As the hotplate cools down
further, the display changes to
until the hotplate has cooled sufficiently.
Activating and deactivating
Select the hotplate, touch the
the 2nd filament circuit is activated
Touch the } symbol again, the extended
cooking zone is activated (the outer fila-
ment circuit of the dual-circuit hotplate is
automatically deactivated)
œ . The display remains lit
} symbol;