Sony ExwaveHAD DXC-390 Mode D'emploi page 29

RGB SYNC
Adds a sync signal to the G signal or R, G and B signals
output from the RGB/SYNC connector.
Selection Function
No sync signal is added to an output signal.
OFF
Adds a sync signal to the G signal output from the
G
RGB/SYNC connector.
Adds sync signals added to the G, B and R signals
RGB
output from the
12P CONNECTOR
Switches the input and output of the
connector (12-pin). Selects the output signal from this
connector when OUT is selected.
Selection Function
Functions as the input connector.
IN
Functions as the output connector.
OUT
Select the output signal with the SIGNAL setting.
HD/VD: Outputs the HD/VD signal.
C. SYNC: Outputs the composite sync signal.
Note
When the CMA-D3/C3CE is connected to the camera with
the CCMC-3MZ connecting cable, you cannot set this item.
Switch between input and output with the IN/OUT switch
on the CMA-D3/D3CE camera adaptor.
For details, refer to the operating instructions of the CMA-
D3/D3CE.
RGB/SYNC connector.
DC IN/VBS
VBS lock
Appears only when an external reference sync signal (VBS
signal) is input. Adjusts the horizontal phase and SC
(subcarrier) phase to synchronize the camera operation with
the reference signal.
Selection Function
H.PHASE Adjusts the horizontal phase within the range from
–20 to +127.
SC.PHASE Roughly adjusts the subcarrier phase by setting to 0°
ROUGH or 180°.
SC.PHASE Finely adjusts the subcarrier phase within the range
FINE from –127 to +127.
HD/VD lock
Appears only when an external reference sync signal (HD/
VD signal) is input. Adjusts the horizontal phase to
synchronize the camera operation with the reference signal.
Select H.PHASE, then adjust the level within the range
from –20 to +127.
29
Chapter 2 Operation (GB)