Publicité
Les langues disponibles
Les langues disponibles
Charging the Battery Pack
Open the battery cover.
Attach the battery pack.
Align the terminal of the
battery pack with this unit.
Close the battery cover.
CAUTION
Be sure to use JVC battery packs.
If you use any other battery packs besides JVC battery packs, safety and
0
performance cannot be guaranteed.
If malfunctions (overcurrent, overvoltage, transmission error, etc) occur, or if any
0
battery manufactured other than JVC is attempted for battery charge, charging
stops. In these cases, the CHARGE lamp blinks quickly for notification.
You can record or play back videos while the AC adapter is connected. (Battery
0
charging cannot be performed during recording or playback.)
Remove the battery when the unit is to be used for a long time. Performance
of the battery may drop if it is left attached to the unit.
The estimated charging time of the supplied battery pack is approximately 3
0
hour 30 minutes.
The charging time is when the unit is used at 25°C (77°F). If the battery pack is
0
charged outside the room temperature range of 10°C to 35°C (50°F to 95°F),
charging may take a longer time or it may not start. CHARGE lamp blinks 2 times
in a slow cycle for notification if the battery charge does not start. Also, please
note that the recordable and playable time may be shortened under some usage
conditions, such as at low temperature.
(Base)
The battery pack is not charged at the
time of purchase.
To detach the battery pack, perform
the above steps in reverse order.
If it is difficult to detach the battery
pack, open the SD card cover. (p.6)
To attach any other battery packs
besides the supplied one, open the SD
card cover before attaching. (p.6 )
Connect the DC connector and
plug in the power.
Charging Lamp
Charging in progress:
Blinks
Charging finished:
Goes out
5
Publicité
